https://forums.autodesk.com/t5/fabrication-cadmep-forum/cable-tray-horizontal-cross/m-p/9418649#M4450 <P>I wanted to start using the fabrication parts for cable tray in Revit.&nbsp; I began to build some Husky Ladder tray.&nbsp; I ran into a rather big snag.&nbsp; The pattern for the horizontal cross only allows for a single size width for the tray.&nbsp; The catalog has horizontal cross cable tray that calls for reducing crosses similar to the Ts.&nbsp; The T pattern has allowances for 2 separate widths, but the cross does not.&nbsp; Is there a way to add the separate dimension width to the cross pattern as it is in the T?&nbsp; I am rather new to ITM parts, but I would really hate not to be able to use the fabrication parts as they seem to be working well, but if I am unable to use a main part like this then I will have to continue to use the ootb cable tray in Revit.</P> Thu, 02 Apr 2020 20:10:15 GMT mikej 2020-04-02T20:10:15Z https://forums.autodesk.com/t5/fabrication-cadmep-forum/cable-tray-horizontal-cross/m-p/9418649#M4450 <P>I wanted to start using the fabrication parts for cable tray in Revit.&nbsp; I began to build some Husky Ladder tray.&nbsp; I ran into a rather big snag.&nbsp; The pattern for the horizontal cross only allows for a single size width for the tray.&nbsp; The catalog has horizontal cross cable tray that calls for reducing crosses similar to the Ts.&nbsp; The T pattern has allowances for 2 separate widths, but the cross does not.&nbsp; Is there a way to add the separate dimension width to the cross pattern as it is in the T?&nbsp; I am rather new to ITM parts, but I would really hate not to be able to use the fabrication parts as they seem to be working well, but if I am unable to use a main part like this then I will have to continue to use the ootb cable tray in Revit.</P> Thu, 02 Apr 2020 20:10:15 GMT https://forums.autodesk.com/t5/fabrication-cadmep-forum/cable-tray-horizontal-cross/m-p/9418649#M4450 mikej 2020-04-02T20:10:15Z