https://forums.autodesk.com/t5/fabrication-cadmep-forum/new-to-fab-cadmep-design-line-dosn-t-draw-in-takeoffs/m-p/9203726#M4369 <P>Hi There</P><P>Looks like you need to setup your button codes for your parts on your service templates.</P><P>There is a section in the Fabrication software help file explaining the basics of how to do this.</P><P>also Autodesk fabrication YouTube channel has good tutorial on button codes and mapping that will help you.</P><P>Hope that helps you enough and good luck!</P> Mon, 16 Dec 2019 04:57:23 GMT Mike_Arcari 2019-12-16T04:57:23Z https://forums.autodesk.com/t5/fabrication-cadmep-forum/new-to-fab-cadmep-design-line-dosn-t-draw-in-takeoffs/m-p/9200952#M4367 <P>I am learning Fab CADmep using a tutorial and when I draw the design lines the boot takeoff is not drawn in. I have attached a screen shot to show what it looks like. Is there something in the settings that causes this?</P> Fri, 13 Dec 2019 13:22:43 GMT https://forums.autodesk.com/t5/fabrication-cadmep-forum/new-to-fab-cadmep-design-line-dosn-t-draw-in-takeoffs/m-p/9200952#M4367 njtingirl 2019-12-13T13:22:43Z https://forums.autodesk.com/t5/fabrication-cadmep-forum/new-to-fab-cadmep-design-line-dosn-t-draw-in-takeoffs/m-p/9203726#M4369 <P>Hi There</P><P>Looks like you need to setup your button codes for your parts on your service templates.</P><P>There is a section in the Fabrication software help file explaining the basics of how to do this.</P><P>also Autodesk fabrication YouTube channel has good tutorial on button codes and mapping that will help you.</P><P>Hope that helps you enough and good luck!</P> Mon, 16 Dec 2019 04:57:23 GMT https://forums.autodesk.com/t5/fabrication-cadmep-forum/new-to-fab-cadmep-design-line-dosn-t-draw-in-takeoffs/m-p/9203726#M4369 Mike_Arcari 2019-12-16T04:57:23Z