topic Re: notches - camduct in Fabrication CADmep Forum https://forums.autodesk.com/t5/fabrication-cadmep-forum/notches-camduct/m-p/9104887#M4332 <P>Hi Danny</P><P>Depends if it is rectangular or circular item and if it has connectors</P><P>Notches and settings are setup in database under fittings tab, you can find these either in pattern switches/developments or pattern options / notches</P><P>&nbsp;</P><P>these settings allow you to notch out or v notch the ends making folding easy without the need to measure</P><P>circular and rectangular work differently so you will need to experiment</P><P>If you can tell me what part you are trying to achieve this on I may be able&nbsp;to give you some specific instruction or point you in the right direction</P><P>&nbsp;</P><P>I'm not an expert but happy to help you</P><P>&nbsp;</P> Thu, 24 Oct 2019 01:42:36 GMT Mike_Arcari 2019-10-24T01:42:36Z notches - camduct https://forums.autodesk.com/t5/fabrication-cadmep-forum/notches-camduct/m-p/9080274#M4312 <P>i would like to add a marker to the spot 0/15 seam connector so the factory doesnt have to mark every one they need to fold</P><P>can someone help with this?</P> Fri, 11 Oct 2019 01:50:35 GMT https://forums.autodesk.com/t5/fabrication-cadmep-forum/notches-camduct/m-p/9080274#M4312 Anonymous 2019-10-11T01:50:35Z Re: notches - camduct https://forums.autodesk.com/t5/fabrication-cadmep-forum/notches-camduct/m-p/9104887#M4332 <P>Hi Danny</P><P>Depends if it is rectangular or circular item and if it has connectors</P><P>Notches and settings are setup in database under fittings tab, you can find these either in pattern switches/developments or pattern options / notches</P><P>&nbsp;</P><P>these settings allow you to notch out or v notch the ends making folding easy without the need to measure</P><P>circular and rectangular work differently so you will need to experiment</P><P>If you can tell me what part you are trying to achieve this on I may be able&nbsp;to give you some specific instruction or point you in the right direction</P><P>&nbsp;</P><P>I'm not an expert but happy to help you</P><P>&nbsp;</P> Thu, 24 Oct 2019 01:42:36 GMT https://forums.autodesk.com/t5/fabrication-cadmep-forum/notches-camduct/m-p/9104887#M4332 Mike_Arcari 2019-10-24T01:42:36Z