https://forums.autodesk.com/t5/fabrication-cadmep-forum/help-with-turning-vanes/m-p/9010588#M4270 <P>Here are a few screen shots, of what I created.</P> Fri, 06 Sep 2019 14:29:25 GMT Anonymous 2019-09-06T14:29:25Z https://forums.autodesk.com/t5/fabrication-cadmep-forum/help-with-turning-vanes/m-p/9010495#M4269 <P>I have created the Airturn Vanes, but they do not show up in any of the elbows that are inserted. There were not any in the data base, so I’m not sure if I created them correctly. I used this as my guide line - <A href="https://knowledge.autodesk.com/support/fabrication-products/learn-explore/caas/CloudHelp/cloudhelp/2017/ENU/Fabrication-UsersGuide/files/GUID-BFE93CDA-C0BA-4885-8FCC-AE31ED7417B7-htm.html" target="_blank">https://knowledge.autodesk.com/support/fabrication-products/learn-explore/caas/CloudHelp/cloudhelp/2017/ENU/Fabrication-UsersGuide/files/GUID-BFE93CDA-C0BA-4885-8FCC-AE31ED7417B7-htm.html</A></P><P>I have adjusted the vane spacing, track Width, etc. with out any of the turning vase being visible. What else do I need to do?</P> Fri, 06 Sep 2019 13:50:37 GMT https://forums.autodesk.com/t5/fabrication-cadmep-forum/help-with-turning-vanes/m-p/9010495#M4269 Anonymous 2019-09-06T13:50:37Z https://forums.autodesk.com/t5/fabrication-cadmep-forum/help-with-turning-vanes/m-p/9010588#M4270 <P>Here are a few screen shots, of what I created.</P> Fri, 06 Sep 2019 14:29:25 GMT https://forums.autodesk.com/t5/fabrication-cadmep-forum/help-with-turning-vanes/m-p/9010588#M4270 Anonymous 2019-09-06T14:29:25Z