https://forums.autodesk.com/t5/fabrication-cadmep-forum/creating-a-new-oval-part-for-fabrication-mep-to-also-use-in/m-p/8721182#M3990 <P>Use CID 118.&nbsp; There is lists of the different CID patterns and what it allows for options.&nbsp; I would recommend looking those up.</P> Wed, 10 Apr 2019 16:35:44 GMT nathan.chapman 2019-04-10T16:35:44Z https://forums.autodesk.com/t5/fabrication-cadmep-forum/creating-a-new-oval-part-for-fabrication-mep-to-also-use-in/m-p/8715001#M3976 <P>I am using a Main Round duct that i need to tap an oval duct into.&nbsp; Is there a CID for a shoe or conical saddle for oval into round duct?&nbsp; Is it possible to get you all to create a block for that if there is a CID for it?&nbsp; Also what about adding a manual damper on the ovals?&nbsp; Is there a way to add that all to be used in Revit?&nbsp; This is all in Fabrication MEP and Revit 2018.</P> Mon, 08 Apr 2019 15:08:26 GMT https://forums.autodesk.com/t5/fabrication-cadmep-forum/creating-a-new-oval-part-for-fabrication-mep-to-also-use-in/m-p/8715001#M3976 Anonymous 2019-04-08T15:08:26Z https://forums.autodesk.com/t5/fabrication-cadmep-forum/creating-a-new-oval-part-for-fabrication-mep-to-also-use-in/m-p/8721182#M3990 <P>Use CID 118.&nbsp; There is lists of the different CID patterns and what it allows for options.&nbsp; I would recommend looking those up.</P> Wed, 10 Apr 2019 16:35:44 GMT https://forums.autodesk.com/t5/fabrication-cadmep-forum/creating-a-new-oval-part-for-fabrication-mep-to-also-use-in/m-p/8721182#M3990 nathan.chapman 2019-04-10T16:35:44Z