https://forums.autodesk.com/t5/fabrication-cadmep-forum/combining-two-system-accidentally/m-p/8483150#M3832 <P>How can i undo this after I have save and close the drawing?</P> Fri, 21 Dec 2018 12:21:49 GMT RidgewayPlumbing 2018-12-21T12:21:49Z https://forums.autodesk.com/t5/fabrication-cadmep-forum/combining-two-system-accidentally/m-p/8483150#M3832 <P>How can i undo this after I have save and close the drawing?</P> Fri, 21 Dec 2018 12:21:49 GMT https://forums.autodesk.com/t5/fabrication-cadmep-forum/combining-two-system-accidentally/m-p/8483150#M3832 RidgewayPlumbing 2018-12-21T12:21:49Z https://forums.autodesk.com/t5/fabrication-cadmep-forum/combining-two-system-accidentally/m-p/8534422#M3853 <P>Can you please attach a snap of your issue?</P> Sat, 19 Jan 2019 06:13:11 GMT https://forums.autodesk.com/t5/fabrication-cadmep-forum/combining-two-system-accidentally/m-p/8534422#M3853 pinaki.rajak 2019-01-19T06:13:11Z https://forums.autodesk.com/t5/fabrication-cadmep-forum/combining-two-system-accidentally/m-p/8559600#M3869 <P>Are you using design line?</P> <P>&nbsp;</P> <P>If yes, I would unfill the design line, copy the entire design line (creates a new design line) &amp; move it over to the right&nbsp;10,000", delete the lines I don't want in the original, delete the opposite in the copy, move the copy back, fill each with the service you want.</P> Tue, 29 Jan 2019 22:20:12 GMT https://forums.autodesk.com/t5/fabrication-cadmep-forum/combining-two-system-accidentally/m-p/8559600#M3869 Anonymous 2019-01-29T22:20:12Z https://forums.autodesk.com/t5/fabrication-cadmep-forum/combining-two-system-accidentally/m-p/8560657#M3871 <P>Thanks for the reply. I figured it out already. There are limits to fabrication CADMEP.</P> Wed, 30 Jan 2019 11:09:51 GMT https://forums.autodesk.com/t5/fabrication-cadmep-forum/combining-two-system-accidentally/m-p/8560657#M3871 RidgewayPlumbing 2019-01-30T11:09:51Z