PCF File Export Question

dbrown — Tue, 23 Oct 2018 20:15:46 GMT

Hello, I'm trying to get a clean PCF out of CADmep. Below is a excerpt from a test I'm working on. Gaskets and bolt set are coming out as couplings. The description comes out right but the component name and SKEY doesn't. Does anyone know where this can be adjusted in CADmep?

FLANGE
END-POINT 109.4882 12.5309 -0.0000 6.0000 PL
END-POINT 105.9882 12.5309 0.0000 6.0000 PL
SKEY FLWN
ITEM-CODE 2
ITEM-DESCRIPTION CS 150# RF WN Flange STD
FABRICATION-ITEM
PIPING-SPEC STD
SPOOL-IDENTIFIER Drawing1-1
ITEM-ATTRIBUTE0 CID=[2522]
WEIGHT 26.0000
COUPLING
END-POINT 105.9257 12.5309 0.0000 6.0000 PL
END-POINT 105.9882 12.5309 0.0000 6.0000 PL
SKEY COCP
ITEM-CODE 3
ITEM-DESCRIPTION ST-700 150# Ring Gasket x1-16th
FABRICATION-ITEM
PIPING-SPEC IPS
SPOOL-IDENTIFIER Drawing1-1
ITEM-ATTRIBUTE0 CID=[2522]
WEIGHT 0.0000
COUPLING
END-POINT 105.9247 12.5309 0.0000 6.0000 PL
END-POINT 105.9257 12.5309 0.0000 6.0000 PL
SKEY COCP
ITEM-CODE 4
ITEM-DESCRIPTION 150# Hex Bolt Set ASTM A307 Gr-B
FABRICATION-ITEM
PIPING-SPEC IPS
SPOOL-IDENTIFIER Drawing1-1
ITEM-ATTRIBUTE0 CID=[2522]
WEIGHT 0.0000
VALVE
END-POINT 95.4247 12.5309 0.0000 6.0000 PL

Re: PCF File Export Question

Anonymous — Wed, 28 Nov 2018 22:54:21 GMT

SKEY should be able to be changed from the connector details of the connector the ITM uses if I'm not mistaken (and I could be).

Re: PCF File Export Question

dbrown — Tue, 07 Apr 2020 14:26:34 GMT

Hi, thanks. This was put on hold for a while at my company but now trying to resolve again. The connectivity column you speak of is grayed out. Is there a procedure to changing this?

topic Re: PCF File Export Question in Fabrication CADmep Forum

PCF File Export Question

Re: PCF File Export Question

Re: PCF File Export Question