https://forums.autodesk.com/t5/fabrication-cadmep-forum/nc-files-sometimes-give-error/m-p/6934787#M2325 <P>This is not a bug. This needs to be adjusted in the machine setup where you can offset the location of the code from the origin.</P> Thu, 09 Mar 2017 17:04:10 GMT dyoung 2017-03-09T17:04:10Z https://forums.autodesk.com/t5/fabrication-cadmep-forum/nc-files-sometimes-give-error/m-p/6566156#M1902 <P>Sometimes NC PRG files cause out of axis error on plasma cutter. When it happens at first piece, I open nesting and move shapes an inch then re write NC. This way I can save sheets but when it happens in the middle of cutting I can't relocate&nbsp;shapes between other islands thus we get some material wasted.</P><P>&nbsp;</P><P>I guess this is a bug caused by CAMduct or BeR algorithm of machine, I am not sure which but it is strange that it can be fixed by just re-arranging nested sheets manually.</P> Fri, 16 Sep 2016 09:01:12 GMT https://forums.autodesk.com/t5/fabrication-cadmep-forum/nc-files-sometimes-give-error/m-p/6566156#M1902 Anonymous 2016-09-16T09:01:12Z https://forums.autodesk.com/t5/fabrication-cadmep-forum/nc-files-sometimes-give-error/m-p/6934787#M2325 <P>This is not a bug. This needs to be adjusted in the machine setup where you can offset the location of the code from the origin.</P> Thu, 09 Mar 2017 17:04:10 GMT https://forums.autodesk.com/t5/fabrication-cadmep-forum/nc-files-sometimes-give-error/m-p/6934787#M2325 dyoung 2017-03-09T17:04:10Z