Create a bracnch using design line with pipe intersecting pipe

Anonymous — Wed, 21 Dec 2016 16:31:02 GMT

I am trying to figure out how to create a stab-in (pipe into another piece of pipe not an olet) using design line.

I have explored the button mapping but I can't figure out which 2 connection types that I need to use. I have attempted a few combinations of shape change and source but no luck.

I have attached an example of what I am trying to achieve.

Re: Create a bracnch using design line with pipe intersecting pipe

simon_dickinson — Thu, 05 Jan 2017 12:08:52 GMT

Have you tried creating a copy of the Curved boot and chagning its angle to 0? See below.

You can then add this to the service tab adding button mapping as "Shoe"

topic Create a bracnch using design line with pipe intersecting pipe in Fabrication CADmep Forum

Create a bracnch using design line with pipe intersecting pipe

Re: Create a bracnch using design line with pipe intersecting pipe