CID 848 Problem in customizing

Anonymous — Thu, 09 Jun 2016 08:05:22 GMT

When I create a "taper bend seperate" based on (CID 848) , I got "invalid geometry" message if a set Bottom width equal to top width. The taper line does not adjust adjust automatically to fit the bend outer radius.

Re: CID 848 Problem in customizing

Jacob_United — Tue, 14 Jun 2016 06:38:07 GMT

This sort of thing also occurs with the round reducer with a branch (forgot the CID), the secondary diameter could not be equal to or larger than the primary which didn't make any sense. I beleive this is just a limitation with the ITM file itself, or made that way. So I'm afraid I can't offer any assistance.

There are issues with a lot of ITM's and very little consistency with the way they were first made (I don't believe Autodesk has made more than a few). This won't change until Autodesk either fixes the ITM's, or they give us the software to make our own. I'd much prefer the latter option but I'll take anything at this point.

topic CID 848 Problem in customizing in Fabrication CADmep Forum

CID 848 Problem in customizing

Re: CID 848 Problem in customizing