https://forums.autodesk.com/t5/fabrication-cadmep-forum/fabrication-camduct-conversation-front-end/m-p/6371012#M1851 I am pretty sure cam duct can not control tables directly - just generate NC code and upload to the controller. Tue, 07 Jun 2016 18:49:34 GMT Anonymous 2016-06-07T18:49:34Z https://forums.autodesk.com/t5/fabrication-cadmep-forum/fabrication-camduct-conversation-front-end/m-p/6370541#M1850 <P>For those of you who are experienced with using and/or installing Fabrication CAMduct, can you tell me whether the software has a conversational front end with something like a touch screen interface to manually control the plasma table if necessary? I have a Cybermation plasma table and am currently using East Coast CAD's conversational front end on a computer connected to the table. The interface looks similar to what's shown in the attached screen.</P> Tue, 07 Jun 2016 15:30:10 GMT https://forums.autodesk.com/t5/fabrication-cadmep-forum/fabrication-camduct-conversation-front-end/m-p/6370541#M1850 Anonymous 2016-06-07T15:30:10Z https://forums.autodesk.com/t5/fabrication-cadmep-forum/fabrication-camduct-conversation-front-end/m-p/6371012#M1851 I am pretty sure cam duct can not control tables directly - just generate NC code and upload to the controller. Tue, 07 Jun 2016 18:49:34 GMT https://forums.autodesk.com/t5/fabrication-cadmep-forum/fabrication-camduct-conversation-front-end/m-p/6371012#M1851 Anonymous 2016-06-07T18:49:34Z