https://forums.autodesk.com/t5/fabrication-cadmep-forum/pieces-not-showing-up-on-plasma-table/m-p/6048026#M1806 <P>I am aving trouble with some pieces not showing up on the plasma table once they are pulled up out there. They are segmented pieces that show to fit on a sheet and even print a sticker for it. But when you pull it up a the plasma table it just shows the lines for when then torch head moves to each starting point but shows no outline of the piece.</P> Fri, 19 Feb 2016 18:45:45 GMT cweaver7 2016-02-19T18:45:45Z https://forums.autodesk.com/t5/fabrication-cadmep-forum/pieces-not-showing-up-on-plasma-table/m-p/6048026#M1806 <P>I am aving trouble with some pieces not showing up on the plasma table once they are pulled up out there. They are segmented pieces that show to fit on a sheet and even print a sticker for it. But when you pull it up a the plasma table it just shows the lines for when then torch head moves to each starting point but shows no outline of the piece.</P> Fri, 19 Feb 2016 18:45:45 GMT https://forums.autodesk.com/t5/fabrication-cadmep-forum/pieces-not-showing-up-on-plasma-table/m-p/6048026#M1806 cweaver7 2016-02-19T18:45:45Z