https://forums.autodesk.com/t5/fabrication-cadmep-forum/fab-cadmep-default-layering-system/m-p/6023665#M981 <P>I have just installed FAB CADmep 2016 and I'm wondering what the default layering system is as it's not based on any Uniclass version as far as I can see,</P><P>&nbsp;</P><P>Example: if I add a length of duct it is created on the layer: M570-GEN_SUP-M3</P><P>&nbsp;</P><P>Regards.</P><P>&nbsp;</P><P>BrynDaff</P> Thu, 04 Feb 2016 10:35:58 GMT Anonymous 2016-02-04T10:35:58Z https://forums.autodesk.com/t5/fabrication-cadmep-forum/fab-cadmep-default-layering-system/m-p/6023665#M981 <P>I have just installed FAB CADmep 2016 and I'm wondering what the default layering system is as it's not based on any Uniclass version as far as I can see,</P><P>&nbsp;</P><P>Example: if I add a length of duct it is created on the layer: M570-GEN_SUP-M3</P><P>&nbsp;</P><P>Regards.</P><P>&nbsp;</P><P>BrynDaff</P> Thu, 04 Feb 2016 10:35:58 GMT https://forums.autodesk.com/t5/fabrication-cadmep-forum/fab-cadmep-default-layering-system/m-p/6023665#M981 Anonymous 2016-02-04T10:35:58Z https://forums.autodesk.com/t5/fabrication-cadmep-forum/fab-cadmep-default-layering-system/m-p/6048097#M1026 <P>Layer names are controlled by what you have in the Service Types tab in the Services Editor.</P><P>You can arrange these to be whatever you want.</P> Fri, 19 Feb 2016 19:17:54 GMT https://forums.autodesk.com/t5/fabrication-cadmep-forum/fab-cadmep-default-layering-system/m-p/6048097#M1026 Anonymous 2016-02-19T19:17:54Z