https://forums.autodesk.com/t5/fabrication-cadmep-forum/i-need-some-insight-please/m-p/9035570#M4289 <P>I run the Hypertherm edge pro ti system and I have been getting into some larger cuts. As my program grows it will cut the shape larger than programmed i;e (program/cut) (12'/12'1/4")-(187"/187 9/16"). I have been through my settings and i have tried to change certain options that I think would help but to no avail. Any thoughts?</P> Thu, 19 Sep 2019 17:00:27 GMT Anonymous 2019-09-19T17:00:27Z https://forums.autodesk.com/t5/fabrication-cadmep-forum/i-need-some-insight-please/m-p/9035570#M4289 <P>I run the Hypertherm edge pro ti system and I have been getting into some larger cuts. As my program grows it will cut the shape larger than programmed i;e (program/cut) (12'/12'1/4")-(187"/187 9/16"). I have been through my settings and i have tried to change certain options that I think would help but to no avail. Any thoughts?</P> Thu, 19 Sep 2019 17:00:27 GMT https://forums.autodesk.com/t5/fabrication-cadmep-forum/i-need-some-insight-please/m-p/9035570#M4289 Anonymous 2019-09-19T17:00:27Z https://forums.autodesk.com/t5/fabrication-cadmep-forum/i-need-some-insight-please/m-p/9144883#M4350 <P>So, the part cut is larger than the part you programmed?</P><P>&nbsp;</P><P>You may have too small a kerf value or the machine needs to be recalibrated.&nbsp;</P><P>&nbsp;</P><P>Is the size equally off on both directions or different?&nbsp; If it's different, than the machine needs to be recalibrated. One of the setup screens allows you to make adjustments for how for the machine moves given a configured input.&nbsp;</P> Wed, 13 Nov 2019 20:01:09 GMT https://forums.autodesk.com/t5/fabrication-cadmep-forum/i-need-some-insight-please/m-p/9144883#M4350 Anonymous 2019-11-13T20:01:09Z