topic REVIT equipment convert in Fabrication CADmep Forum

REVIT equipment convert

Anonymous — Fri, 06 Apr 2018 11:07:10 GMT

I have exported a lot of equipment from REVIT to CADmep in the past and am doing my first item using 2018 and when I type "processrun" it is now asking for the ".MAP" file. Did I miss something in the upgrade?

Re: REVIT equipment convert

nathan.chapman — Fri, 06 Apr 2018 17:23:43 GMT

That dialogue has been there for a while. Once its set you wont't have to set it again. Your older version already has the location to a map file hence not seeing that popup. To find were you current is, go to the version you don't get this popup and processrun. The dialogue box should appear and in the bottom left corner hit Read Mapping. Take note of the location and have the new version point to this.

Re: REVIT equipment convert

Anonymous — Fri, 06 Apr 2018 17:25:56 GMT

Thank you, I actually found the file by mistake.