https://forums.autodesk.com/t5/fabrication-cadmep-forum/inside-turning/m-p/6049148#M1807 <P>On inside Turning- The tool enters and leaves on the center line</P><P>but between passes it pulls out past the center line--</P><P>Is there any way to control that so the tool does not pull back</P><P>past the center line??</P><P>&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp; Thank you--Rick</P> Sun, 21 Feb 2016 01:53:11 GMT Anonymous 2016-02-21T01:53:11Z https://forums.autodesk.com/t5/fabrication-cadmep-forum/inside-turning/m-p/6049148#M1807 <P>On inside Turning- The tool enters and leaves on the center line</P><P>but between passes it pulls out past the center line--</P><P>Is there any way to control that so the tool does not pull back</P><P>past the center line??</P><P>&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp; Thank you--Rick</P> Sun, 21 Feb 2016 01:53:11 GMT https://forums.autodesk.com/t5/fabrication-cadmep-forum/inside-turning/m-p/6049148#M1807 Anonymous 2016-02-21T01:53:11Z