https://forums.autodesk.com/t5/fabrication-cadmep-forum/connector-report-for-s-amp-d/m-p/5659605#M1712 <P>Creating reports for most items not difficult. Creating an accurate report for S&amp;D proving to be most challenging. Anyone out there with good connector setup?</P> Mon, 01 Jun 2015 14:47:20 GMT Anonymous 2015-06-01T14:47:20Z https://forums.autodesk.com/t5/fabrication-cadmep-forum/connector-report-for-s-amp-d/m-p/5659605#M1712 <P>Creating reports for most items not difficult. Creating an accurate report for S&amp;D proving to be most challenging. Anyone out there with good connector setup?</P> Mon, 01 Jun 2015 14:47:20 GMT https://forums.autodesk.com/t5/fabrication-cadmep-forum/connector-report-for-s-amp-d/m-p/5659605#M1712 Anonymous 2015-06-01T14:47:20Z https://forums.autodesk.com/t5/fabrication-cadmep-forum/connector-report-for-s-amp-d/m-p/5666448#M1713 <P>Hi Joe</P> <P>&nbsp;</P> <P>The default Imperial Install has a Connector List Breakdown, if you copy that to your Contents MIS folder you can use that, you may have to change the Filter for the Connector Type to include S&amp;D.</P> <P>&nbsp;</P> <P>I have attached the one I use to this post.</P> <P>&nbsp;</P> Fri, 05 Jun 2015 15:19:40 GMT https://forums.autodesk.com/t5/fabrication-cadmep-forum/connector-report-for-s-amp-d/m-p/5666448#M1713 davedykes 2015-06-05T15:19:40Z