Visual LISP, AutoLISP and General Customization

Visual LISP, AutoLISP and General Customization

Reply
*Gustavo_Guidi
Message 1 of 2 (60 Views)

LAYER Command problem

60 Views, 1 Replies
03-27-2009 01:41 PM
I have a program that uses for set a layer and turn it off the following
string

(command "_layer" "_S" lay "_OFF" lay "_Y" "")

The problem is that in one machine with 2008 the command doesn`t prevent to
you about

Really want layer "$$$_AUX_PLAN" (the CURRENT layer) off? y

so the "_Y" must not exist and it creates an error. Is it there any variable
that set this to ON or OFF in order to checkit so the question is made or
not and to give to different way depending on the values of it?

Thanks in advance
*Gustavo_Guidi
Message 2 of 2 (60 Views)

Re: LAYER Command problem

03-27-2009 02:07 PM in reply to: *Gustavo_Guidi
I found that EXPERT variable was the problem

Thanks anyway


"Gustavo_Guidi" escribió en el mensaje
news:6150988@discussion.autodesk.com...
I have a program that uses for set a layer and turn it off the following
string

(command "_layer" "_S" lay "_OFF" lay "_Y" "")

The problem is that in one machine with 2008 the command doesn`t prevent to
you about

Really want layer "$$$_AUX_PLAN" (the CURRENT layer) off? y

so the "_Y" must not exist and it creates an error. Is it there any variable
that set this to ON or OFF in order to checkit so the question is made or
not and to give to different way depending on the values of it?

Thanks in advance
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.