Visual LISP, AutoLISP and General Customization

Visual LISP, AutoLISP and General Customization

Active Member
Posts: 8
Registered: ‎11-22-2011
Message 1 of 1 (115 Views)

Extracting Drawing Descriptions to an Index Table on a separate dwg

115 Views, 0 Replies
09-05-2012 08:13 AM

I would like to be able to extract a Drawing attribute from each sheet of my project that would be in the drawing description column of my Index sht. For example, if sht1 is my Index sht, sht2 is my 3phase power dist., sht3 is my AC Logic, and sht 4 is PLC I/O. I would like to be able to have this information to auto populate my table to eliminate duplicate effort and possibly forgetting to update the Index sht if that should ever happen :smileyhappy: . Maybe I should not use a drawing attribute, but rather a project attribute?

Please advise

Thanks so much


Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.