Visual LISP, AutoLISP and General Customization

Visual LISP, AutoLISP and General Customization

*Expert Elite*
Posts: 5,389
Registered: ‎09-13-2004
Message 11 of 12 (207 Views)

Re: Continuous Offset with last entity & diff dist...

06-05-2012 08:02 AM in reply to: vinodhkumar

vinodhkumar wrote:

i want continuous doubleoffset with last entity in give logic

I can't help with, but I'm wondering: what does "continuous doubleoffset with last entity" really mean?  I can understand a continuous Offset command with the last entity automatically selected to be Offset again, as in the OP here.  But if you are doing a double Offset [assuming that you mean Offset to both sides], then the last entity will be one of the two entities resulting from that double Offset, and depending on how it's done, you may not have any control over which one that is, so automatically selecting it for the next double Offset may not get you the one you want.  Or am I misunderstanding what you want to do?

Kent Cooper
Posts: 5
Registered: ‎06-04-2012
Message 12 of 12 (196 Views)

Re: Continuous Offset with last entity & diff dist...

06-05-2012 10:23 PM in reply to: Kent1Cooper

thanks for reply.with my logic i am getting both sides offset of polyline with selected offset requirement is that doubleiffset continuous when i press anywhere in the location till i press ESC key.i am sending my written logic.

please send logic quickly .more thanks.............

Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.