Vault General Discussion

Vault General Discussion

Reply
Contributor
jdow
Posts: 13
Registered: ‎10-11-2011
Message 1 of 4 (264 Views)
Accepted Solution

Folder Level Properties and Property Compliance

264 Views, 3 Replies
10-11-2011 08:09 PM

Does Vault Pro 2012 support folder level properties with compliance enforcement?

I know you can assign properties to folders, but can we enforce their use?

 

Thanks

John

Unfortunately, the property compliance does not fully work in 2012.

 

-Dave

Employee
minkd
Posts: 533
Registered: ‎06-07-2010
Message 2 of 4 (252 Views)

Re: Folder Level Properties and Property Compliance

10-12-2011 11:43 AM in reply to: jdow

Unfortunately, the property compliance does not fully work in 2012.

 

-Dave



Dave Mink
Data Management
Autodesk, Inc.
Distinguished Contributor
Brausmith
Posts: 303
Registered: ‎11-20-2008
Message 3 of 4 (177 Views)

Re: Folder Level Properties and Property Compliance

05-08-2012 03:56 PM in reply to: jdow

Hi Dave,

Sorry to did up an older post, but I think it might relate to my issue in some way.

 

Does the Property Compliance just not work properly in general in 2012, or only in specific ways?

The reason I ask is that I have some transitional Property Compliance setup, and despite doing so the file is still allowed to change to a Released state. Or is there possibly something else I haven't considered at play?

Regards,
Chad
Employee
minkd
Posts: 533
Registered: ‎06-07-2010
Message 4 of 4 (172 Views)

Re: Folder Level Properties and Property Compliance

05-09-2012 09:27 AM in reply to: Brausmith

In 2012, Property Compliance doesn't work for Folders.  To the best of my knowledge, it works fine on Files.

In 2013 Property Compliance now works for Folders, and Lifecycles are available to Folders.

 

I believe you can define whether or not compliance is required to enter a state in the Life Cycle Definition dialog.

 

-Dave



Dave Mink
Data Management
Autodesk, Inc.
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
New button for Platinum & Gold Subscription customers
Gold & Platinum Subscription customers can alert Autodesk if they require assistance with their forum post

Manufacturing Community
The Manufacturing Community provides additional access to tips, tutorials, blogs and networking with peers.