Vault General Discussion

Reply
Contributor
CodeMonkey831
Posts: 23
Registered: ‎04-01-2010
Message 1 of 1 (81 Views)

Default Revision

81 Views, 0 Replies
02-16-2012 06:54 AM

Is it possible for a revision scheme to display the secondary (and tertiary) characters as a default for a file?  Assigning a category to a file will only show the primary character.  As of now, to do this, it must be done manually with a "Revise" operation on that file and selecting the next revision.  Basically the request is to display "A.0.0" as the defualt assignment when a file is assigned a category.

Announcements
New button for Platinum & Gold Subscription customers
Gold & Platinum Subscription customers can alert Autodesk if they require assistance with their forum post

Manufacturing Community
The Manufacturing Community provides additional access to tips, tutorials, blogs and networking with peers.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.