Vault General Discussion

Reply
Distinguished Contributor
nbradbury
Posts: 342
Registered: ‎11-13-2006
Message 1 of 1 (69 Views)

AIP 2010 simulation

69 Views, 0 Replies
10-16-2009 01:35 PM
I am trying to run a simulation with a weldment. After about 20 seconds of computing Inventor gives me a warning that says "Not enough memory to continue operation." I watched the memory usage during the task and my computer never used more than 2.09GB while Invneotro was running. Is there a predetermined limit of RAM that simulation will try to use?
Thanks,
Nathan
Announcements
New button for Platinum & Gold Subscription customers
Gold & Platinum Subscription customers can alert Autodesk if they require assistance with their forum post

Manufacturing Community
The Manufacturing Community provides additional access to tips, tutorials, blogs and networking with peers.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.