Utility Design General Discussion

Utility Design General Discussion

Active Contributor
Posts: 41
Registered: ‎06-05-2013
Message 1 of 3 (484 Views)
Accepted Solution

GPS points

484 Views, 2 Replies
07-31-2013 08:34 AM

I have tried a couple of times using GPS points in AUD 2013 R1.  What is the best way to get symbols to osnap to the GPS points?  Do I need to install a Civil 3D object enabler?  Or is this an issue that has been resolved in R2 and 2014?

Active Contributor
Posts: 41
Registered: ‎06-05-2013
Message 2 of 3 (466 Views)

GPS points in AUD 2014

08-08-2013 09:53 AM in reply to: donald.e.clark

Now able to use GPS points.  Downloaded Civil 2014 Object Enabler then created New Design and assign coordinate system.  Then used Base Map command -> Attach Drawing.

Posts: 194
Registered: ‎08-21-2007
Message 3 of 3 (204 Views)

Re: GPS points

03-26-2014 10:50 AM in reply to: donald.e.clark

Or if you do not have C3D you can import your GPS points using Map3D survey data store.


then snap to the points.


At some point I can see a requirement similay to C3D description file where by, based on a point description you could insert AUD models instead of C3D point objects.


Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New Utility Design Category!

The Utility Design forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.