Utility Design General Discussion

Reply
Distinguished Contributor
kulfi
Posts: 909
Registered: ‎09-29-2005
Message 1 of 2 (245 Views)

Actual 3d Cable

245 Views, 1 Replies
10-31-2013 01:24 AM

when i am using "Draw Underground" Primary cable why it does not ask for the shape of the cable and the elevation of the cable like for Example i have a 33KVA round shape cable how will i draw this cable.

thanks

Kulfi
Electronics Engineer

Pind Saudi Arabia



Active Contributor
jpab
Posts: 37
Registered: ‎10-02-2008
Message 2 of 2 (220 Views)

Re: Actual 3d Cable

11-05-2013 08:32 AM in reply to: kulfi

Hello Kulfi,

i don't know if AUD knows if the cable is round or not, but to tell you the truth i have never seen an electric cable or wire that wasn't round. as far as the eveleation you can set that manually by changing the Z value, but i dont know if AUD has a setting for elevation of underground cables (at least i haven't seen one) if there was a setting i would think it would have to be in the industry model on every cable as you could have different depth\elevation for each type (secondary, 200 amp primary and  600 amp feeder) of cable because at least here in the US they have different required minimum depths.

 

Jim

Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New Utility Design Category!

The Utility Design forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.