Active Member
Posts: 9
Registered: ‎01-12-2010
Message 1 of 2 (1,212 Views)

Spatial Report Design TOPOBASE

1212 Views, 1 Replies
04-04-2011 05:09 AM

I'am new to topobase administrator and i'm trying to create a spatial selection report.
i'm using gas data model and i want to select all pipes that have an atribute smaller than a certain value. I want to print all the features but each on a different page witn zoom extends and and havind some atributs listed at the bottom of the page.

do you have a better idea rather than using Topobase spatial selection reports?

Thanks in advance.

Active Contributor
Posts: 41
Registered: ‎09-18-2007
Message 2 of 2 (1,164 Views)

Re: Spatial Report Design TOPOBASE

07-14-2011 10:45 AM in reply to: amalia_stan

You may already have your answer but a spatial report is an easy way to get your answers.  I assume you will be choosing small portions of your system not the complete system since you are using spatial.  Make sure you use style: Formular to get each on a separate page.  Module Name must be set to Topobase.SpatialExportTool and ParameterID=1 and SpatialMask = anyinteract.

I hope this helps.

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.