The Break Room (Non-Technical Discussions)
Non-technical discussions will be held here to give community members a chance to connect and get to know one another.

The Break Room (Non-Technical Discussions)

Reply
Member
spl2112
Posts: 3
Registered: ‎07-30-2013
Message 1 of 2 (319 Views)

Zcorp Printer wanted

319 Views, 1 Replies
07-30-2013 12:55 AM

Hi People,

 

I use Autodesk Inventor and have now decided that I want to increase my knowledge on 3D printing, therefore I am looking for a 3d printer by Zcorp.  

 

I have done some research and have decided on zcorp as they seem to provide what I am looking for in a printer.  I have also looked at new systems, but my god they are expensive hence looking for a used one that is in good contion. Preferbly cheap, the cheaper the better as this is for me at home.

 

Any help or pointers in a cheap printer will be most gratefully recieved.

 

Best regards

*Expert Elite*
troma
Posts: 2,524
Registered: ‎05-21-2008
Message 2 of 2 (301 Views)

Re: Zcorp Printer wanted

07-30-2013 05:49 AM in reply to: spl2112
I heard a story that a couple of guys in Toronto were crowd-sourcing funding for the cheapest 3D printer that they're going to make themselves. Sounds like they were getting up to their goal and going to get going on it soon.


Credit where credit is due! Give kudos or accept as solution whenever you can.

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Are You Going To Be @ AU 2014? Feel free to drop by our AU topic post and share your plans, plug a class that you're teaching, or simply check out who else from the community might be in attendance. Ohh and don't forgot to stop by the Autodesk Help | Learn | Collaborate booths in the Exhibit Hall and meet our community team if you get a chance!