Loft command rail control

[gunnarid]

How do I control the "rail" when I use loft. It only snaps to midpoint. I need to snap or control the angle when lofting circles.

[jeff_strater]

You can just drag the endpoints of those "point mapping" lines.  See the attached video.

Hope this helps 

Jeff Strater (Fusion development)

[gunnarid]

Yes, I'm dragging the "point mapping" lines but I like som control while dragging like angle snapping or better numerical angular input.

[schneik.fastmail.com]

What would these angles be in relation too?

Does angle make sense on non circular profiles?

just trying to image how we make this a general solution.