insert mesh inside insert menu - Autodesk Community

Community

Forums

Fusion Design, Validate & Document

Stuck on a workflow? Have a tricky question about a Fusion (formerly Fusion 360) feature? Share your project, tips and tricks, ask questions, and get advice from the community.

Reply

Message 1 of 3

271 Views, 2 Replies

logically it makes sense - mouse movement wise it is terrible

where it was before made more sense close to TS convert and mesh to brep.

Claas Kuhnen

Faculty Industrial Design – Wayne State Universit

Chair Interior Design – Wayne State University

Owner studioKuhnen – product : interface : design

2 REPLIES 2

Message 2 of 3

It's been a while since this post. Is it still a problem to find Insert > Mesh on the Insert menu (where applicable)?

Thanks,

Phil Eichmiller
Software Engineer
Quality Assurance
Autodesk, Inc.

Message 3 of 3

All there for used to the new positions

Claas Kuhnen

Faculty Industrial Design – Wayne State Universit

Chair Interior Design – Wayne State University

Owner studioKuhnen – product : interface : design

Reply

Can't find what you're looking for? Ask the community or share your knowledge.

Post to forums