Community
Fusion Design, Validate & Document
Stuck on a workflow? Have a tricky question about a Fusion (formerly Fusion 360) feature? Share your project, tips and tricks, ask questions, and get advice from the community.
cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

Fusion crashed just by switching from TL to DM

1 REPLY 1
Reply
Message 1 of 2
cekuhnen
189 Views, 1 Reply

Fusion crashed just by switching from TL to DM

turned of capture design history and Fusion crashed.

 

CER_100461771

 

Screen Shot 2014-08-24 at 1.56.18 PM.png

Claas Kuhnen

Faculty Industrial Design – Wayne State Universit

Chair Interior Design – Wayne State University

Owner studioKuhnen – product : interface : design

1 REPLY 1
Message 2 of 2
Phil.E
in reply to: cekuhnen

Using the attached model I cannot achieve the crash. It's possible this bug has been fixed since you posted this. Can you check again?

 

Thanks,





Phil Eichmiller
Software Engineer
Quality Assurance
Autodesk, Inc.


Can't find what you're looking for? Ask the community or share your knowledge.

Post to forums  

Autodesk Design & Make Report