Error T point

[siddhardha.mjm]

Hello everyone ,

I am a new bie to fusion 360 and i am trying to model a car,

when i try to smooth the model from the box mode  using Alt+3 it is not happening 

So i tried to find the problem using repair body in which it shows i have a T point error at three areas below the wheel arch

flange area .

Need help in finding the solution to this points . Refer the attached image

[innovatenate]

Could you use the export archive command and then upload the F3D file to this forum posting?

[siddhardha.mjm]

Refer the below link for the file

https://www.dropbox.com/s/yi9x03ritt9jsg1/Basic%20car.f3d

[deyop · Accepted solution]

In the version you provided us it looks like you may have selected the AutoRepair and the Error T was resolved.  However I did see the creasing problem that can be associated with having an interior corner.  Here is an image of the area I am refering to.

This can be addressed in a couple of ways.  You could remove the faces that create the interior corner or select all the surrounding edges and extrude them in Edit Form (Alt key) move.  This is a bad characteristic of T-Splines we are working at removing.  We have prototypes now that will eliminate that problem with interior corners.  I put an image of the results of our prototype.  This will be available in a future release after testing insures stability and interaction with all commands will be safe.

Nice start on your car model.

Thanks