Discussion Groups

Simulation Moldflow Insight

Reply
Contributor
klp2kor
Posts: 24
Registered: ‎12-29-2009

Unrealistic Temperature plot

246 Views, 2 Replies
05-23-2013 03:09 AM

Hello,

 

In a simmetrical part, I observed an unrealistic flow front temperature difference. Please refer the attached images.

I have also included the snapshot of 3D mesh quality used.

 

Can someone comment, what could be the actual cause for this variation and how to fix it.

 

Thanks and Regards,

KL

Please use plain text.
*Expert Elite*
madhukeshwart
Posts: 292
Registered: ‎03-18-2009

Re: Unrealistic Temperature plot

05-24-2013 02:57 AM in reply to: klp2kor

This is very common question, rises when you using 3d analysis.

 

Option 1- Re-mesh the part and re-run the analysis.

 

Option 2- Re-mesh with fine elements and don't correct much the mesh after converting to 3D.

 

Option 3- some variaitions, you can ignore and take decision, when you are sure, it is problem of 3d analysis .

Madhukeshwar Talwar

FIAT-CHRYSLER ATC, Chennai
mail: madhukeshwart@gmail.com
09600060862
======================================
Please use . Accept as Solution and Give Kudos as appropriate to further enhance these forums. Thank you! .....
Please use plain text.
Contributor
klp2kor
Posts: 24
Registered: ‎12-29-2009

Re: Unrealistic Temperature plot

06-03-2013 06:01 AM in reply to: klp2kor

Thanks Madhukesh.

Please use plain text.