Sink Mark Depth Result in Dual Domain

[Anonymous]

Is there any way one can get sink mark depth result using dual domain meshing?

[nordhb]

Hi,

the Sink marks, depth result plot is generated when using Midplane mesh type and analysis technology.
The result is not available for Dual Domain mesh type and analysis technology.
See: Sink marks, depth result

Hope this clarifies.
Regards,
Berndt

[madhukeshwart]

You can refer 'the Sink marks estimate result' displays the calculated depths of sink marks in the part, when using DD or 3D mesh

[inba.oneway777]

Hi,

Sink mark results are more accurate in Midplane & 3D mesh. DD mesh unable to predict the sink mark accurately. because DD mesh works based on the mesh matching.

[teopado89]

Hi everyone, 

i'd like to ask: what about "sink marks index" in dual domain analysis? Can i consider this result reliable?

Thanks

[inba.oneway777]

Sink mark index in %.

for ex: sink mark index is 0.2% at the location of 1mm thick region.

the depth of the sink mark is 0.002mm.