Discussion Groups

Simulation Moldflow Insight

Reply
New Member
t230381
Posts: 2
Registered: ‎11-25-2012

Runner diameters after runner balance analysis

296 Views, 3 Replies
11-25-2012 11:01 PM

We use hot runner system and set target pressure after that we choose "runner balance" in Analysis sequence tab. The runner balance analysis is trying to achieve the target pressure by changing the diameters of the runners. How can we know these diameters of the runners?

Please use plain text.
Active Member
ashwinkumarnr
Posts: 10
Registered: ‎03-27-2012

Re: Runner diameters after runner balance analysis

01-03-2013 12:08 AM in reply to: t230381

HI,

 

After runner balance analysis is complete, the softeare will create a study file with final runner sizes. Just as in best gate analysis.

 

Hope this is what you asked for!!

 

 

Regards,

Ashwin

Please use plain text.
*Expert Elite*
madhukeshwart
Posts: 311
Registered: ‎03-18-2009

Re: Runner diameters after runner balance analysis

01-08-2013 07:21 AM in reply to: t230381
you need to set maximum / runner sizes other wise... Moldflow will give very smaller or larger diameters as solutions
Madhukeshwar Talwar

FIAT-CHRYSLER ATC, Chennai
mail: madhukeshwart@gmail.com
09600060862
======================================
Please use . Accept as Solution and Give Kudos as appropriate to further enhance these forums. Thank you! .....
Please use plain text.
New Member
t230381
Posts: 2
Registered: ‎11-25-2012

Re: Runner diameters after runner balance analysis

01-08-2013 10:30 PM in reply to: ashwinkumarnr

Dear Ashwin,

 

Thank you very much for your reply.

I've read the study file, but I've not seen the final sizes of runner.

Could you please show me more clearly?

 

Please use plain text.