Discussion Groups

Simulation Moldflow Insight

Reply
Member
faridrijal
Posts: 5
Registered: ‎09-17-2012

optimum runner balance

419 Views, 2 Replies
11-29-2012 07:35 PM

Hai all

please advice how to find optimum diameter using moldflow insight, I have mold with 16 cavities

for now i just maintain the pressure  not over than 120 Mpa(based on my injection machine)

 

Thanks

-Farid-,  

 

Please use plain text.
Board Manager
raalteh
Posts: 264
Registered: ‎04-14-2009

Re: optimum runner balance

11-30-2012 11:30 AM in reply to: faridrijal

Hi Farid,

 

I don't know if you have looked at the runner balancing option in the Moldflow software yet? You can find some of information on this in the wiki help here

Hanno van Raalte,

Product Manager for Autodesk Simulation Moldflow products
Please use plain text.
Active Member
sadashivpimple
Posts: 6
Registered: ‎01-10-2013

Re: optimum runner balance

01-31-2013 05:02 AM in reply to: faridrijal

To simulate the meltflipper effect you must have your runner cold as well as hot in 3D use 12 to 20 layers of tetra for your runner system and 8 layers of tetra for you are part to balance a runner system

 

Thanks

 

 

Please use plain text.