Discussion Groups

Simulation Moldflow Insight

Reply
Member
5 Posts
0 Kudos
Registered: ‎09-17-2012

optimum runner balance

431 Views, 2 Replies
11-29-2012 07:35 PM

Hai all

please advice how to find optimum diameter using moldflow insight, I have mold with 16 cavities

for now i just maintain the pressure  not over than 120 Mpa(based on my injection machine)

 

Thanks

-Farid-,  

 

Board Manager
267 Posts
14 Kudos
Registered: ‎04-14-2009

Re: optimum runner balance

11-30-2012 11:30 AM in reply to: faridrijal

Hi Farid,

 

I don't know if you have looked at the runner balancing option in the Moldflow software yet? You can find some of information on this in the wiki help here

Hanno van Raalte,

Product Manager for Autodesk Simulation Moldflow products
Active Member
6 Posts
0 Kudos
Registered: ‎01-10-2013

Re: optimum runner balance

01-31-2013 05:02 AM in reply to: faridrijal

To simulate the meltflipper effect you must have your runner cold as well as hot in 3D use 12 to 20 layers of tetra for your runner system and 8 layers of tetra for you are part to balance a runner system

 

Thanks