Discussion Groups

Simulation Moldflow Insight

Reply
New Member
samica
Posts: 2
Registered: ‎06-01-2011

modeling bubbler

887 Views, 10 Replies
06-01-2011 07:46 AM

hi every one ,

 

for my anlysis i need a bubbler cooling system , i have draft that with the help of the instruction in the help (modeling bubbler )

but every time after the mesh my bubbler have intersetion , i have try the the mesh repair Winzar to corect the intersection , but nothing change .

so if same one can help me please.

thank u so mutch

samica :smileyhappy:

Please use plain text.
Valued Contributor
nishit78
Posts: 82
Registered: ‎08-05-2009

Re: modeling bubbler

06-02-2011 04:30 AM in reply to: samica

Try running the analysis. The intersection might be OK (as long as the part mesh has no intersections).

 

It may be just how the bubblers are modeled. Did you have overlapping curves for bubblers (which is acceptable). Even if no overlapping curves it may still show intersections. Just make sure that the bubblers dont intersect with the part mesh.

Please use plain text.
New Member
samica
Posts: 2
Registered: ‎06-01-2011

Re: modeling bubbler

06-02-2011 05:18 AM in reply to: samica

Thanks for reply 

 

the part mesh have not intersection , the intersection are in the bubbler , i have run the analysis and she was succesful with 7 warrning, the result of the the warp is olso get better , but i dont now if thos intersection dont make the anlysis not good , and how can i solve those warning .

thanks so much ( and sorry for my bad english )

samica 

Please use plain text.