Discussion Groups

Simulation Moldflow Insight

Reply
Contributor
19 Posts
1 Kudo
Registered: ‎05-08-2009

Midplane & 3D advantage

211 Views, 1 Replies
09-20-2013 04:52 AM

Hi,

 

We are working on Midplane for our analysis and looking at advantage of 3D mesh.Kindly let me know your comments +ve/-ve...

Thanks in advance for your time.

 

Regards,

Rajesh PV

Distinguished Contributor
165 Posts
18 Kudos
Registered: ‎05-05-2011

Re: Midplane & 3D advantage

09-25-2013 03:09 AM in reply to: rajeshkumarpv

If part wall thickness is on higher side you can always opt for 3D mesh, but your analysis time will increase here. You can use 3D mesh when part is complex, thickness of wall is high, some extra features etc.

Midplane gives you freedom when part is simple, not much features, & time is very short.