Discussion Groups

Simulation Moldflow Insight

Reply
Contributor
p.hammer
Posts: 19
Registered: ‎03-14-2013

map heating results of part insert to moldflow?

217 Views, 3 Replies
04-22-2014 03:30 AM

Hello, 

 

I did a heating simulation in CFD for a part insert.

 

Now I would like to map these results as starting temperature for a moldflow analysis.

 

Is this possible?

 

Philipp

Please use plain text.
*Expert Elite*
madhukeshwart
Posts: 292
Registered: ‎03-18-2009

Re: map heating results of part insert to moldflow?

05-11-2014 10:03 AM in reply to: p.hammer

At present it is not available... But  

 

If you have pre-heat temperature.. you can assign one value of temperature to insert. But cant map different temperature for each element 

Madhukeshwar Talwar

FIAT-CHRYSLER ATC, Chennai
mail: madhukeshwart@gmail.com
09600060862
======================================
Please use . Accept as Solution and Give Kudos as appropriate to further enhance these forums. Thank you! .....
Please use plain text.
Active Contributor
phammer
Posts: 36
Registered: ‎07-29-2011

Re: map heating results of part insert to moldflow?

05-11-2014 11:13 PM in reply to: madhukeshwart

HI everybody, 

 

answer I got from support was interesting.

 

Only workaround they had was to split the insert in several bodies and assing different starting temperature. 

 

Greeting Philipp

Please use plain text.
*Expert Elite*
madhukeshwart
Posts: 292
Registered: ‎03-18-2009

Re: map heating results of part insert to moldflow?

05-14-2014 09:14 AM in reply to: phammer
it is like for each element ...assign a value..!!
Madhukeshwar Talwar

FIAT-CHRYSLER ATC, Chennai
mail: madhukeshwart@gmail.com
09600060862
======================================
Please use . Accept as Solution and Give Kudos as appropriate to further enhance these forums. Thank you! .....
Please use plain text.