Discussion Groups

Simulation Moldflow Insight

Reply
Board Manager
raalteh
Posts: 266
Registered: ‎04-14-2009

Hotfix DL20323299 for Parallelized 3D warp now available

217 Views, 0 Replies
09-10-2012 08:56 AM

Dear Moldflow users,

 

This is a quick note to let you know that a hotfix is available for a 3D warp issue. When 3D warp is used, using multiple threads, results in very extreme, in some exceptional cases the warpage results are extreme and unrealistic (several thousand mm deflections). The problem has been described in the blog post here.

 

excessive warp.JPG

 

The issue has been resolved in hotfix DL20323299 and can be downloaded from subscription center or from the support page (here).

 

The issue has been resolved on both Linux and Windows, The hotfix requires the product to be on Moldflow 2013 Service Pack 2. Please read the 'readme files', as they contain a description of the issue, as well as installation instructions.

There is a separate fix for the adviser product, which can be found here.

 

Best regards,

 

Hanno van Raalte

Hanno van Raalte,

Product Manager for Autodesk Simulation Moldflow products
Please use plain text.