hello everyone,
newly i am going todo analysys for 2 colour mold ( co injection mold). anyone help me to wher i can get this information and procedure?. because this is my first project about co injection mold...
Hi,
I suggest you start with Autodesk Simulation Moldflow Insight 2014 Help:
You can get quite some information from:
ASMI Help > User's Guide > Molding processes > Co-injection and Bi-injection molding processes
ASMI Help > User's Guide > Molding processes > Co-injection and Bi-injection molding processes >
> Co-injection analysis > Co-injection molding overview
In Autodesk Simulation Moldflow Insight 2014 Co-injection and Bi-injection can be simulated.
Co-injection involves the injection of two different materials using the same injection location.
Bi-injection is the injection of two different materials at separate injection locations, with independent process controls.
Hope this helps as a starting point for you.
Regards,
Berndt
Hi,
you can do following for all mesh types of Midplane, Dual Domain and 3D:
Fill + Pack + Overmolding Fill + Overmolding Pack.
For 3D mesh type also:
Fill + Pack + Overmolding Fill + Overmolding Pack +Warp.
The Overmolding analysis consists of a 2-step process where a normal Fill+Pack analysis is performed on the first cavity (first component stage),
which is then followed by a Fill+Pack analysis on the overmolding cavity (overmolding stage).
The consecutive overmolding stage on the second cavity uses a different material from the first analysis,
and the first component temperatures are used as the initial temperatures.
Hope this clarifies.
Regards,
Berndt
Can't find what you're looking for? Ask the community or share your knowledge.