Discussion Groups

Simulation Moldflow Insight

Reply
Member
3 Posts
0 Kudos
Registered: ‎01-11-2013
Accepted Solution

Cannot find Injection-Compression under Molding Processes

203 Views, 2 Replies
01-11-2013 12:14 AM

Hallo,

 

I want to run an injection compression analysis but cannot find the injection compression process at the Molding Prcess Setup. Also the Tools > Workspace > Customize Menue did no exist. Can you please help me!Using Moldflow Insight 2013

Product Support
485 Posts
41 Kudos
Registered: ‎03-23-2009

Re: Cannot find Injection-Compression under Molding Processes

01-11-2013 03:23 AM in reply to: heinemma

Hi,

the Injection Compression analysis is mesh dependent, and in ASMI 2013 it is available for mesh type Midplane.

Please, change to mesh type Midplane, and you should then be able to see molding process for Injection Compression Molding.

Regards,
Berndt



Berndt Nordh
Member
3 Posts
0 Kudos
Registered: ‎01-11-2013

Re: Cannot find Injection-Compression under Molding Processes

01-11-2013 04:00 AM in reply to: heinemma

That's it!

 

Thanks for helping me!