Discussion Groups

Simulation Moldflow Insight

Reply
Contributor
mtrujil1
Posts: 21
Registered: ‎01-09-2014

Air Trap Result

176 Views, 1 Replies
04-08-2014 01:03 PM

hello user!!

 

i have a one question, i suppose very easy, now a ran a fill + pack analysis on reactive molding, and i want review the air trap results, but i want see the results in  opaque and closed by one circule (normally pink or red). my question is how can i cghange the display result? now i already changed from transparency to opaque, but i could not change the other thing.

 

Note: my analysis was done With 3D mesh.

 

regards.

 

 

Please use plain text.
Active Contributor
JayMuller
Posts: 39
Registered: ‎05-07-2013

Re: Air Trap Result

04-24-2014 04:25 AM in reply to: mtrujil1

 

Hi

Don't think it is possible as you wish...with an opaque Body you can't see defects which are shown inside

The rest would be Single Contour checked and Value 0.5

 

Regards,

 

Jay

Please use plain text.