0 Kudos
prabu27

Mesh Confusion

Status: New Idea
by Valued Contributor prabu27 on ‎01-22-2014 09:04 PM

Hello,

                Normally we are facing trouble to select correct mesh type for the product . whether use DD or 3D .Instead of this ,if it is possible You can change the option like always use 3D meshing.

then try to improve the mesh accuracy , result accuracy and reduce the meshing time and analyse time  if it is possible.

 

Prabu.K 

Comments
by Employee on ‎01-23-2014 02:38 AM

3D meshing is not giving benefit for well designed plastic part.

You will just end up with huge mesh.

 

Remember dual domain and midplane use the assumption that the flow is staying in the element plane.

3D it can goes in all direction.

So when you have part with chunky area, it is better to use 3D.

When your part have a proper ration thickness/width, the flow will most likely stay 2 dimensional, and DD will be better.

Announcements
IdeaStation Guidelines
Review guidelines and best practices
before posting a new idea.