Discussion Groups

Simulation Moldflow Adviser

Reply
Board Manager
raalteh
Posts: 256
Registered: ‎04-14-2009

Real time analysis Adviser plug-in for Inventor 2012 is available on Sub Center

930 Views, 2 Replies
05-05-2011 10:45 AM

Dear Autodesk Adviser users,

 

You may have seen the new near real time fill preview feature in your Adviser 2012 product. If you are on active subscription, you can now download a special plug-in from subscription center.

 

This new plug-in into Inventor and Inventor LT 2012 can provide near real time feedback to design decisions you make, while you are developing the plastic product. You will get direct feedback on how the design desisions impact the manufacturability, cost and sustainability of the product. The easy to interpret feedback can ensure that the design process moves in the right direction and that the part is developed to conform to plastic part design guidelines.

 

An early preview version of the plug-in for Pro/Engineer V3 is available upon request and can be requested per email: hanno.van.raalte@autodesk.com

 

Hanno

 

Hanno van Raalte,

Product Manager for Autodesk Simulation Moldflow products
Please use plain text.
New Member
wesgegg
Posts: 1
Registered: ‎05-15-2011

Re: Real time analysis Adviser plug-in for Inventor 2012 is available on Sub Cen

05-15-2011 09:59 AM in reply to: raalteh

When will this be ready to download for Pro/E ?

 

Thanks, Wes

Please use plain text.
Board Manager
raalteh
Posts: 256
Registered: ‎04-14-2009

Re: Real time analysis Adviser plug-in for Inventor 2012 is available on Sub Cen

05-16-2011 10:06 AM in reply to: wesgegg

Hi Wes,

 

I can can send you the preview version if you send me an email. The product is functional, but we are improving the usability of some of the workflows and we would appreciate your feedback. Though I cannot tell you the release date, we are on target to meet our deadline.

 

Hanno 

 

 

Hanno van Raalte,

Product Manager for Autodesk Simulation Moldflow products
Please use plain text.