Discussion Groups

Simulation Moldflow Adviser

New Member
1 Posts
0 Kudos
Registered: ‎12-27-2013
Accepted Solution

Mold Type Selection in Ribbon Greyed Out

354 Views, 1 Replies
12-27-2013 06:32 AM



             I have installed Mold Flow Adviser 2013, while using any CAD model the mold type option on the ribbon is always greyed out. How can I fix this issue ?




Product Support
485 Posts
41 Kudos
Registered: ‎03-23-2009

Re: Mold Type Selection in Ribbon Greyed Out

01-08-2014 01:45 AM in reply to: ttubsa

this depends on the product installed.

Autodesk Simulation Moldflow Adviser comes in three products:
1) Moldflow Adviser Standard
2) Moldflow Adviser Premium
3) Moldflow Adviser Ultimate

To compare look at:

If you have installed Moldflow Adviser Standard product, the Mold Type button will always be greyed out,
as Moldflow Adviser Standard is for simulation on cavity only, a single cavity with no runner system "Part Only".

To use Mold Type you need the Moldflow Adviser Premium or Moldflow Adviser Ultimate product
to model single cavity or multi-cavity with runner systems.

Hope this clarifies.


Berndt Nordh