Discussion Groups

Simulation Moldflow Adviser

Reply
Active Member
bowen
Posts: 7
Registered: ‎08-02-2012
Accepted Solution

Minor Bugs

446 Views, 4 Replies
02-14-2013 10:57 AM

I've encountered two minor annoyances in Moldflow Adviser 2013:

 

1) I can no longer display the results of an analysis from the Tasks panel by clicking or double-clicking on their check boxes. To display or hide them I must now right-click on the results set and click Show. Occassionally the problem will go away and allow me to display the results by single-clicking them, but this occurs seldomly and seemingly at random so I can't determine the cause.

 

2) The Quality Prediction results have reversed for me; they now display areas of high quality in red and low quality in green. This issue began just recently and I am unsure of the cause.

 

As I said these are just minor annoyances, but if anyone has suggestions for fixing these quirks please let me know.

 

Thanks,

Bryan

Please use plain text.
Active Member
bowen
Posts: 7
Registered: ‎08-02-2012

Re: Minor Bugs

02-14-2013 11:00 AM in reply to: bowen

Oh and I forgot - I also can't open analyses by clicking on them in the task panel - I have to minimize all windows within Moldflow and drag the analysis that I want to open in to the empty gray area to open it. Shouldn't I be able to double-click these to open them?

Please use plain text.
Active Member
bob.schlosser
Posts: 7
Registered: ‎12-30-2011

Re: Minor Bugs

02-18-2013 08:13 AM in reply to: bowen

I have a similar issue with check boxes not working and menus not mapping as desired.   My workstation set up has two monitors.  This issue only happens when Moldflow is on my second monitor.  It doesn't happen when it is run on my primary monitor.  This seems to be a windows based problem according to Google. 

 

If you have two monitors try the other one and see if the problem still exists.

Please use plain text.
Active Member
bowen
Posts: 7
Registered: ‎08-02-2012

Re: Minor Bugs

02-21-2013 07:11 AM in reply to: bob.schlosser

Moving the window to my primary monitor seems to work, which is inconvenient for me because I typically leave Moldflow on a secondary monitor. I also had problems with DFM on multiple monitors.

 

I hope that Autodesk fixes this in a future update.

 

My quality prediction results are still reversed though...

Please use plain text.
Active Member
bowen
Posts: 7
Registered: ‎08-02-2012

Re: Minor Bugs

02-28-2013 10:32 AM in reply to: bowen

I was contacted by Autodesk support and told to try running the registry cleaner:

 

C:\Program Files\Autodesk\Simulation Moldflow Adviser 20XX\bin\advcleanreg.exe

 

This fixed my issue with reversed quality prediciton results.

Please use plain text.