Discussion Groups

Simulation Moldflow Adviser

Reply
Board Manager
raalteh
Posts: 254
Registered: ‎04-14-2009

Autodesk Moldflow Structural Alliance 2011 for ANSYS and Abaqus

1079 Views, 2 Replies
10-19-2010 03:04 PM

Dear Customers,

 

Autodesk Moldflow Structural Alliance allows structural Engineers to make use of mechanical properties calculated by Autodesk Moldflow Adviser and Insight injection molding simulation software. Using material properties calculated by Autodesk Moldflow Adviser and Insight is particularly critical when using fiber filled polymers, as the products stiffness is largely determined by the manufacturing process.

Autodesk Moldflow Structural Alliance uses a mapping process to bring the mechanical properties that are calculated on a Dual Domain or 3D model in Autodesk Moldflow Adviser and Insight to the Structural Analysis package. The mapping process allows the Autodesk Moldflow products and the Structural Analysis package to use the mesh that is best suited for the application. As a result, the Structural Analysis on the plastic part or assembly can be done quickly, without compromising accuracy.

 

Autodesk Moldflow Structural Alliance (AMSA) 2011 is now available for both ANSYS and Abaqus. This release supports:

  • ANSYS 11 & 12 (both Classic and Workbench, 32 and 64 bit). 
  • Abaqus 6.7 and 6.9 (32 and 64 bit).

 

To download AMSA 2011 for Abaqus or ANSYS (Classic or Workbench), please log in to Subscription center: http://subscription.autodesk.com

 

 

Best regards,

 

Hanno van Raalte

Hanno van Raalte,

Product Manager for Autodesk Simulation Moldflow products
Please use plain text.
New Member
chenyi2010
Posts: 1
Registered: ‎10-29-2010

Re: Autodesk Moldflow Structural Alliance 2011 for ANSYS and Abaqus

10-30-2010 05:57 PM in reply to: raalteh

where ?I can't find.

Please use plain text.
Board Manager
raalteh
Posts: 254
Registered: ‎04-14-2009

Re: Autodesk Moldflow Structural Alliance 2011 for ANSYS and Abaqus

11-12-2010 02:57 PM in reply to: chenyi2010

Hi,

 

I'm sorry for the late response, but I only just now saw your question. To be able to use Autodesk Moldflow Structural Alliance 2011 with the Adviser products, you will need to have an active Autodesk Moldflow Adviser Advanced 2011 license.

1851i35FDE3827F9EA9BD

 

If you have an Adviser Design or an Adviser Manufacturing license, you will not see the Autodesk Moldflow Structural Alliance products listed.

 

Best regards,

 

Hanno

Hanno van Raalte,

Product Manager for Autodesk Simulation Moldflow products
Please use plain text.