Discussion Groups

Simulation Moldflow Adviser

New Member
1 Posts
0 Kudos
Registered: ‎05-05-2011

Analysis for iover molding

448 Views, 1 Replies
05-05-2011 07:25 AM


I have to perform mold flow  analysis on a second molding for a connector to see the pressure to which the metal fins are exposed, but I don't knot how to prepare the assembly file for it (pro-e), any help in very welcome


Board Manager
267 Posts
14 Kudos
Registered: ‎04-14-2009

Re: Analysis for iover molding

05-05-2011 11:24 AM in reply to: reynaomar



The analysis you are looking for can be done with the Insight product using a core deflection analysis. You would model both the inserts and the plastic part. You would then assign the appropriate material to the insert and indicate where the inserts are fixed/restrained from movement in the mold.

During the filling simulation, you can then incorporate the movement of the insert due to the plastic pressure and determine when the inserts get exposed.


However ... this anlaysis cannot be performed in the Adviser products; it requires Autodesk Moldflow Insight.



Hanno van Raalte,

Product Manager for Autodesk Simulation Moldflow products