Wrong spinner direction for part, surface, layer in "Create remote load"

[AndrewWeighell7348]

I have been using Simulation since Algor but I still get caught out by this feature.  Hopefully, it should take 30 seconds to tidy up.

i.e. The up/down spinners operate in the wrong direction for the the new part number, surface number, layer number.

Normally, one expects a number to increase if the up arrow is clicked.   The create remote load arrows do the opposite!

Also, the spinner increment stops arbitrarily at 100.  After that, numbers have to be typed in by hand.  It does not affect me very often but also catches me out every time when my now hard wired expectation is not fullfilled!    

[Sualp.Ozel]

I am using Simulation Mechanical 2015 R1 and this seems to be working as you have specified